Part Number

DJM:300434

Description

1965-72 Ford F-100 3 inch front/4 inch rear Lowering kit by DJM

2 WD King pin trucks only, Note, there are 2 different shock styles for this truck. 1 - A loop mount with bushings on both ends of the shock, use front 1409, rear 1900 2 - A loop mount with a bushing on the bottom mount with a threaded stem on top, use front 1415, rear 1910

What are Dreambeams? Ford I-Beam trucks have a much different suspension than most other trucks. Spindles are non-existent for lowering, using lowered coil springs cause more alignment problems than you can solve. Then we built Dream Beams. Twin I-Beams In 1965 Ford introduced their “Twin I Beam” suspension, a simple, rugged suspension consisting of a pair of cast beams in the rough shape of an I. Looking like a steel I beam found in building construction, the factory beams are cast ductile iron and machined just like spindles. This makes them precise and repeatable, every beam machined exactly the same. A very important attribute when it comes to alignment. Alignment can be a sticky issue because there is very little if any adjustment available on I-beam suspensions (No upper control arm). This just means in order to align properly, beams must be accurate. Which brings us back to – What are Dream Beams? You have probably seen dropped I-beams made of three flat pieces of metal welded together in the shape of an I. Some are pretty accurate and then there are others. The problem with beams constructed this way is in the design itself. It requires welding three flat metal surfaces with long welds. This generates a lot of heat, which causes warping, otherwise known as “weld creep”. This would not be a problem if you had some control of the “creep”, but sadly it warps the steel a little different every time. This makes the beams manufactured this way a little different every time one is welded up. Big trouble for alignment. But why is this important? Because there is no way to adjust caster with beams. It is set by the construction of the beam, and if the beam is not consistent (because of weld creep) during construction you will likely have some alignment issues.

Image

DJM:300434

Picture is for representation only and may not be of the actual part

Retail Pricing

$1,924.83

$1,732.35

Parts Shipping Information

Weight in lbs.	Dimensions in inches (if Available)	Dimensional Weight	Ship Code
90		90	3

Inventory

Available: 0
On Order: 0

Kit Part Inventory - All parts must be listed as in stock in order for this to be a complete kit

Part#	Description	Available	On Order
DJM:DB30043	1965-79 Ford F100 3 inch drop Dream Beams (for trucks with king pins only)	1	0
DJM:HS11304	1965-72 F100 4 inch Hanger, Shackle	1	0

Vehicles this part fits

1965 to 1972 Ford F-Series No ap notes have been added

1965 – 1972 Ford F-100 3/4 Complete Lowering kit by DJM